产品简介
l NMB 滚珠轴承延长使用寿命和低噪音. NMB ball bearing guarantee long life;
l 超小体积输出高负压(真空度)和大风量. Compact size but output high pressure and airflow.
l 体积和重量特别适合安装在便携式工具或者设备里面.Very Suitable for compact system or tools.
l 无刷电机驱动电路板外置. Can Choose wonsmart External driver controller.
l 外置驱动器可以实现PWM或者0~5V无极调速. External driver controller can change speed by PWM or 0~5v signal.
l WS140110BS-48-150-NZ01建议使用 48VDC-8A 的开关电源;WS140110BS-48-150-NZ01 choose 48VDC-8A power supplier.
产品型号P/N: | 单位 | WS140110BS-48-150-NZ01 |
额定电压 Rated Voltage | [V] | 48VDC |
噪音等级Noise | [dBA] | 88 |
电机转子磁铁极对数 Motor Pole pairs | 2 | |
相间电阻 Resistance --Phase to phase | [Ohm] |
电机种类 Motor type | 三相直流无刷 Three Phase Brushless |
轴承 Bearing type | 日本NMB轴承 NMB Ball bearing |
线圈耐压 Dielectric Strength | 500VDC for 1min |
绝缘等级 Insulation Class | Class F |
防护等级 Protect Class | IP54 |
使用环境温度 Operating Temperature range | -20deg.C~+50deg.C(没有水珠凝结No Condensation) |
使用寿命(40度温度环境额定负载点运行) Service Life L10(40 C degree Rated Operation Point) | 10,000小时 10,000 hours |
接线方法(Winding Type) | 三角行接法(Delta) |
霍尔电角度 Hall effect Sensor | 120 |
转速与霍尔脉冲关系 | 1Hz=30 r/min |
驱动器电路 Driver Type | Internal(内置) |
产品重量 Product Mass | 1.1kg |
注意事项Notes:
1,不要用最大风压作为工作点,此时风机出风很小,风机运行不安全;
Do not use max pressure as working point, this point is not safe since airflow is too small.
2,风机的进风口加一个过滤网可以延长风机轴承的寿命;
To add a filter onto the inlet can make the blower run longer time;
3,风叶的正确旋转方向是逆时针;
The right impeller run direction is CCW.
型号<Part NO> | WS140110BS-48-150-NZ01 |
电压<Voltage> | 48VDC |
完全开口<Open> | |
转速<Speed> | 15,000rpm |
电流<Current> | 6.8A |
风量<Air flow> | 108m³/h |
完全闭合<Sealed> | |
转速<Speed> | 17,500rpm |
电流<Current> | 3.7A |
风压<Air pressure> | 8kPa |
Wiring diagram接线顺序 | |||
Pin1 | Red | 红色 | +5V |
Pin2 | Purple | 紫色 | Hall A |
Pin3 | Green | 绿色 | Hall B |
Pin4 | Grey | 灰色 | Hall C |
Pin5 | Black | 黑色 | GND |
Pin6 | Yellow | 黄色 | Phase A |
Pin7 | Blue | 蓝色 | Phase B |
Pin8 | White | 白色 | Phase C |